« previous next »
Pages: [1]

Author Topic: How to enable failover ?  (Read 7145 times)

yellowtail

  • Zen Apprentice
  • *
  • Posts: 5
  • Karma: +0/-0
    • View Profile
How to enable failover ?
« on: November 08, 2011, 05:34:36 am »
Dear forum,

i have a new installation zentyal, 2 WAN and 1 LAN.
when i need to configure failover, always show "WAN Failover event is not enabled". I'm searching, where is to enable this?
somebody can help me, please

regards
Logged

creatron

  • Zen Apprentice
  • *
  • Posts: 5
  • Karma: +0/-0
    • View Profile
Re: How to enable failover ?
« Reply #1 on: November 14, 2011, 06:00:59 am »
Events can be enabled in the Module status , clicking the status check box.
Logged

robb

  • Guest
Re: How to enable failover ?
« Reply #2 on: November 14, 2011, 11:39:02 am »
What creatron says (from the zentyal documentation): Failover is implemented as a Zentyal event. To use it, you first need to have the Events module enabled, and after this enable the WAN Failover event.

http://doc.zentyal.org/en/routing.html#configuring-wan-failover-in-zentyal
Logged

yellowtail

  • Zen Apprentice
  • *
  • Posts: 5
  • Karma: +0/-0
    • View Profile
Re: How to enable failover ?
« Reply #3 on: November 16, 2011, 05:33:25 am »
Ok, i found it.

regards
Logged
Pages: [1]
« previous next »