Messages

1

Installation and Upgrades / Re: Can't access web interface if firewall is turned on

« on: January 26, 2012, 03:07:34 am »

I have a similar problem. I have set up zentyal on a server with 2 nics, but only enabled eth1 as static with address 192.168.10.10. The home network setup is cable modem to wireless/giga ethernet router which is the dhcp server for the network (to which the wireless components of the network connect as do 2 ethernet enabled devices) to giga switch to which the zentyal server and remaining ethernet connected devices connect. The DHCP server (router) is set up with most of the ethernet connected devices with static addresses. The dhcp server and the zentyal server are in agreement about both the zentyal server's MAC and DHCP address. I can ping all devices on the internal network from the zentyal server. I can connect to the zentyal server from within the internal network, using both the web interface and ssh in a terminal window. I cannot ping or connect to the WAN from the zentyal server.
I assumed this was a setup issue, so I reinstalled the software. same issue. I then disabled all services, same issue. I then restarted only network (and its dependencies), same issue.
I am sure it is a config issue, but can't figure out what it is.
any help appreciated.