Messages

1

Installation and Upgrades / Re: Zentyal 7 issues inside LXD

« on: May 13, 2021, 08:01:21 pm »

How do you install it under LXd ? I never managed to do so because of https://github.com/lxc/lxd/issues/3442#issuecomment-311622221 and support for quotas

I use BTRFS and quotas are not that much of a problem, I use it more for AD purposes

Anyway I got an issue with ifup and ifdown, I do not have netplan or network manager installed.
can anyone give me a hint on what to do?

2

Installation and Upgrades / Re: Zentyal 7 issues inside LXD

« on: March 18, 2021, 01:28:31 pm »

Update fixed some issues, samba, nginx and uwsgi do not start at boot.
default route does not apply
restarting zenyal service makes all net config vanish.

3

Installation and Upgrades / Zentyal 7 issues inside LXD

« on: March 17, 2021, 04:20:13 am »

This happens in upgraded or clean install on a LXD container
I have the following issues to report
- defining default routes at startup
- losing all IP address when firewall is installed

I cannot trace what is happening but it's related with zentyal service but only after firewall is installed, I know it is not much...

Tried to add fixed ip and default route, Zentyal web console loads but AD management interface is not working even if it is installed.

4

Directory and Authentication / Re: Dynamic vlan 802.1x with LDAP or RADIUS?

« on: October 08, 2019, 04:21:25 pm »

RADIUS is really easy of configuring simply read the docs. You can configure your network interface as VLAN Trunk https://doc.zentyal.org/en/firststeps.html#vlan-trunk

I think this should solve your problem.

Cheers!

802.1x is dynamicly assigning vlans to switch ports based on you authentication, this does not solve my problem...

5

Directory and Authentication / Dynamic vlan 802.1x with LDAP or RADIUS?

« on: October 07, 2019, 07:42:32 pm »

Hi

I am trying to get 802.1x configured for AP and a switch.

is it possible to add config to Samba4 LDAP or RADIUS and how?

I dont see any interface that allows this, so manually?

i.e.
Tunnel-Type:0 = VLAN
Tunnel-Medium-Type:0 = IEEE-802
Tunnel-Private-Group-Id:0 = "216"