Zentyal Forum, Linux Small Business Server

Zentyal Server => Installation and Upgrades => Topic started by: yellowtail on November 08, 2011, 05:34:36 am

Title: How to enable failover ?
Post by: yellowtail on November 08, 2011, 05:34:36 am

Dear forum,

i have a new installation zentyal, 2 WAN and 1 LAN.
when i need to configure failover, always show "WAN Failover event is not enabled". I'm searching, where is to enable this?
somebody can help me, please

regards

Title: Re: How to enable failover ?
Post by: creatron on November 14, 2011, 06:00:59 am

Events can be enabled in the Module status , clicking the status check box.

Title: Re: How to enable failover ?
Post by: robb on November 14, 2011, 11:39:02 am

What creatron says (from the zentyal documentation): Failover is implemented as a Zentyal event. To use it, you first need to have the Events module enabled, and after this enable the WAN Failover event.

http://doc.zentyal.org/en/routing.html#configuring-wan-failover-in-zentyal

Title: Re: How to enable failover ?
Post by: yellowtail on November 16, 2011, 05:33:25 am

Ok, i found it.

regards