Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
1
Installation and Upgrades / Zentyal 7 issues inside LXD
« on: March 17, 2021, 04:20:13 am »
This happens in upgraded or clean install on a LXD container
I have the following issues to report
- defining default routes at startup
- losing all IP address when firewall is installed
I cannot trace what is happening but it's related with zentyal service but only after firewall is installed, I know it is not much...
Tried to add fixed ip and default route, Zentyal web console loads but AD management interface is not working even if it is installed.
I have the following issues to report
- defining default routes at startup
- losing all IP address when firewall is installed
I cannot trace what is happening but it's related with zentyal service but only after firewall is installed, I know it is not much...
Tried to add fixed ip and default route, Zentyal web console loads but AD management interface is not working even if it is installed.
2
Directory and Authentication / Dynamic vlan 802.1x with LDAP or RADIUS?
« on: October 07, 2019, 07:42:32 pm »
Hi
I am trying to get 802.1x configured for AP and a switch.
is it possible to add config to Samba4 LDAP or RADIUS and how?
I dont see any interface that allows this, so manually?
i.e.
Tunnel-Type:0 = VLAN
Tunnel-Medium-Type:0 = IEEE-802
Tunnel-Private-Group-Id:0 = "216"
I am trying to get 802.1x configured for AP and a switch.
is it possible to add config to Samba4 LDAP or RADIUS and how?
I dont see any interface that allows this, so manually?
i.e.
Tunnel-Type:0 = VLAN
Tunnel-Medium-Type:0 = IEEE-802
Tunnel-Private-Group-Id:0 = "216"
Pages: [1]