Messages

1

Installation and Upgrades / Re: No connection to https://localhost after zentyal update

« on: December 30, 2011, 07:33:06 pm »

The redis port change to 6380 in /etc/redis/redis.conf worked for me. I have not restarted to make sure the fix is permanent.

2

Installation and Upgrades / Re: CONFIGURE A STATIC IP FOR eth0

« on: March 12, 2011, 09:46:50 pm »

I have a question. Is your static IP address in the same network segment, so the first three sets of digits in the IP address are the same? My Zentyal server works perfectly with the external (WAN) using DHCP and the internal GigE (LAN) having static 192.168.100.xxxx address, and my DHCP server (AirPort) excludes the bottom 100 addresses for the internal network. Both NICs are on the same IP segment (192.168.100.1/24) however. All PCs in the network can connect with one another and the internet using dhcp addresses, and with the servers inside the router which have static IP addresses.

Also during Zentyal installation I turned off the router option, and installed with the DHCP option on the router-facing NIC configuration, then configured the internal NIC as static during the initial Zentyal configuration. It got the default gateway from the dhcp-configured NIC I assume. It only asked for the IP address and the net mask.

It's concerning it doesn't work. Can you ping one from the other? You may be way ahead of that suggestion already, in which case you're past my level of expertise. Good luck.