Zentyal Forum, Linux Small Business Server

Zentyal Server => Installation and Upgrades => Topic started by: Ziya Karan on September 14, 2010, 07:17:23 pm

Title: Zentyal 2.0 detects secondary Network Card but always shows "Down"
Post by: Ziya Karan on September 14, 2010, 07:17:23 pm

Hello there experienced folks and Zentyal Support Team

We have recently installed Zentyal 2.0 32 bit edition on a legacy Dual-Socket Pentium 3 Xeon server with on-board Broadcom Ethernet Controller. Recognizes as eth0 And works - All Right -

After the Installation of UTM and Gateway components and completed the installation, we have installed another Ethernet card with VIA Rhine 3 - 6105M chip.  Zentyal detects it too and recognizes as eth1  -

And problem starts here. Thus, whichever as we configure "eth1" as WAN, or LAN, or configure IP manually or try to get IP from modem DHCP (planned for use as WAN), it doesn't respond in any kind and  It always labeled as "Down" Status  in  Zentyal's Dashboard. 

Is that a driver issue ? Or is there any option or command to make enable and use secondary ethernet interface ?

Any suggestions appreciated. Thanks for your help -

Title: Re: Zentyal 2.0 detects secondary Network Card but always shows "Down"
Post by: Ziya Karan on September 15, 2010, 02:53:08 pm

Solved by manually configuring /etc/network/adapters file