Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
1
Installation and Upgrades / Bridge beetween two network interface
« on: April 01, 2017, 01:03:33 am »
Hi guys,
i have installed the Zentyal 5.0 release but in its GUI i don't find the possibility to set two network card eth0 and eth1 in "bridge mode" but only static, dhcp, 802.1d or bond mode
Thanks a lot
i have installed the Zentyal 5.0 release but in its GUI i don't find the possibility to set two network card eth0 and eth1 in "bridge mode" but only static, dhcp, 802.1d or bond mode
Thanks a lot
Pages: [1]