Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
1
Installation and Upgrades / Re: Video in ebox
« on: May 17, 2012, 11:27:58 pm »
It is possible.... you have to edit the sip.conf (/usr/share/zentyal/stubs/asteriks/sip.conf) and add the videocodecs by adding the following line for each user or phone:
allow=h264,h263
then restart asteriks... works like a charm
allow=h264,h263
then restart asteriks... works like a charm
2
Installation and Upgrades / Re: Zarafa - outlook 2007
« on: September 19, 2010, 08:54:14 pm »
I had the same problem... to make this work your client (outlook) must be configured to use the standard IMAP-port i.e. 143. For this you have to disable the imap service in communications>mail>general and save the settings. Under Office>Groupware you enable IMAP gateway and save the settings as well...
Verify your outlook accountsettings and it should work :-) It does for me !
Good luck
Verify your outlook accountsettings and it should work :-) It does for me !
Good luck
3
Installation and Upgrades / [Solved]Howto activate PHP on webroot /var/www
« on: September 18, 2010, 08:31:51 pm »
Hello,
I'm trying to install a cms (drupal/joomla) on the webroot (/var/www) but it seems php is default not enabled at this location... I see that zarafa is using php so it must be installed. Can someone help me to find this out? (it must be a config thing I hope)
Update
As apache runs as user www-data, I did a chown -R root:www-data /var/www as root.
This made the use of php scripts possible.
I'm trying to install a cms (drupal/joomla) on the webroot (/var/www) but it seems php is default not enabled at this location... I see that zarafa is using php so it must be installed. Can someone help me to find this out? (it must be a config thing I hope)
Update
As apache runs as user www-data, I did a chown -R root:www-data /var/www as root.
This made the use of php scripts possible.
Pages: [1]