Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - antechno

Pages: [1]
Can you help me? From wiki documentation in Zentyal 4.1 is possibile to set the "bridge mode" in the network page but in 5.0 release?

Installation and Upgrades / Bridge beetween two network interface
« on: April 01, 2017, 01:03:33 am »
Hi guys,
i have installed the Zentyal 5.0 release but in its GUI i don't find the possibility to set two network card eth0 and eth1 in "bridge mode" but only static, dhcp, 802.1d or bond mode

Thanks a lot

Pages: [1]