Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - jjmontes

Pages: 1 ... 3 4 [5]
A few points:

1) While Zentyal normally supports overriding configuration templates, by writing them to /etc/zentyal/stubs, the 'interfaces' file is an exception as it is generated by Zentyal core without using a template. Thus, this approach won't be valid for this.

2) On Zentyal 2.2, the wireless setup file is placed in /usr/share/zentyal-network/setup-wireless. If you see filenames containing 'ebox', then you are probably using an older version than 2.2? If you installed Zentyal packages from Ubuntu repositories, then I strongly suggest you to use a Zentyal CD or Zentyal APT repository (PPA) instead.

3) You basically need to add a configuration-hook, so the script is executed after every time that Zentyal writes the interfaces file. Information about using the setup-wireless script can be found at (a bit outdated, but still valid).


Thorsten, that's pretty surprising. I believe that no firewall update has been published recently... what update do you speak about?

In any case, rules should not dissapear at all. Can you dump your configuration and send it through?

In order to obtain it you would run the following command:

Code: [Select]
/usr/share/zentyal/shell "use EBox::Config::Redis; EBox::Config::Redis->new()->export_dir_to_yaml('/ebox', '/tmp/zentyalconf.dump', 1);"
This should create a /tmp/zentyalconf.dump which you can send to (don't post it here, as the file could contain sensitive information).

Installation and Upgrades / Re: AD sync only transfers some users
« on: May 24, 2010, 02:09:32 pm »
Hi there.

I am also affected by this issues. I can't get passwords synchronized properly.

Is there any workaround to this? Could ebox-usercorner be used to at least change LDAP passwords? Will they be overwritten again by ebox-ad-sync?

I am using eBox 1.4 from eBox PPA on Ubuntu 8.04.


Spanish / Re: Codificación de caractéres para PDC SAMBA
« on: June 24, 2009, 02:41:12 pm »
Hemos tenido que realizar un cambio similar aquí, y eso que el locale de nuestro usuario root (que es el usuario que ejecuta samba) es UTF8.

Me pregunto si no sería recomendable cambiar el valor de unix charset a UTF8, ya que me parecería una opción más estable y menos proclive a generar problemas...

Pages: 1 ... 3 4 [5]