This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: 1 [2]
16
Installation and Upgrades / 2 Internal LAN
« on: June 07, 2011, 04:37:28 pm »
Hello!
I defined 2 networks on my Zentyal.
eth0 = 10.6.19.0/24
eth1 = 10.6.20.0/24
They are defined as networks "internal ".
My question is:
Is it normal for there have no connection between the two networks?
Is it necessary to define a "bridge"?
From one of the two networks, I can not even ping one machine from another network.
Yet the rules of the firewall are left by default
Thank you in advance
I defined 2 networks on my Zentyal.
eth0 = 10.6.19.0/24
eth1 = 10.6.20.0/24
They are defined as networks "internal ".
My question is:
Is it normal for there have no connection between the two networks?
Is it necessary to define a "bridge"?
From one of the two networks, I can not even ping one machine from another network.
Yet the rules of the firewall are left by default
Thank you in advance
17
Installation and Upgrades / SUBNET by electronic bridge
« on: March 31, 2011, 09:30:15 pm »
Hello,
Here's my problem.
I have a network (10.6.19.0/24) defines as "internal" on eth0.
On this network, there is a subnet (10.6.18.0/24) connected by a bridge electronics.
But there is no traffic flowing between two networks. I set different value at the firewall, but there is no traffic between the networks.
If I "ping" one machine subnets (10.6.18.0/24) it works.
By cons, a simple HTTP or SSH connection does not work.
I defined a Static Route to the subnets.
I tried directly connecting the electronic gateway to a third network card (eth2) which I installed in my server Zentyal and defining it as "external" and it ............. works!!
But I can not use the networks like this.
Zentyal Before, we used SME SERVER and it worked fine.
My question: how to have Zentyal allow me access subnets through the electronic bridge without having to add a network card.
Thank you in advance
N.B.: Excuse me my English
Here's my problem.
I have a network (10.6.19.0/24) defines as "internal" on eth0.
On this network, there is a subnet (10.6.18.0/24) connected by a bridge electronics.
But there is no traffic flowing between two networks. I set different value at the firewall, but there is no traffic between the networks.
If I "ping" one machine subnets (10.6.18.0/24) it works.
By cons, a simple HTTP or SSH connection does not work.
I defined a Static Route to the subnets.
I tried directly connecting the electronic gateway to a third network card (eth2) which I installed in my server Zentyal and defining it as "external" and it ............. works!!
But I can not use the networks like this.
Zentyal Before, we used SME SERVER and it worked fine.
My question: how to have Zentyal allow me access subnets through the electronic bridge without having to add a network card.
Thank you in advance
N.B.: Excuse me my English
Pages: 1 [2]