Zentyal Forum, Linux Small Business Server
Zentyal Server => Installation and Upgrades => Topic started by: linker on February 26, 2008, 11:39:38 am
-
Hello Guys,
Does the E-Box work with a SATA HDD normally? I have a problem with E-Box installation: it says that the hard drive is not found.
My motherboard is Foxconn P4M9007MB (http://www.foxconnchannel.com/EN-US/product/Motherboards/detail_overview.aspx?ID=en-gb0000221) and SATA HDD is Hitachi HDS721680PLA380 (http://www.hitachigst.com/hdd/support/7k160/7k160.htm).
Could you please get any advice?
BTW, I have tried to install PFSense before (http://www.pfsense.com/). It is a FreeBSD based filrewall. Could it be a cause of problem (maybe it had made geometry of HDD reconfiguration).
I have formatted and converted a file system many times to different types (FAT, etx2, ext3, etc).
Also I have tried to install Windows XP and Suse Linux 10.3 and thay are installed successfully, but E-Box is not.
Thanks a lot.
-
Try installing a newer kernel since the eBox installer contains a quite old kernel (2.6.12).
Follow this howto:
http://trac.ebox-platform.com/wiki/Document/FAQ/HowToInstallWithNewKernels
I hope this helps.
-
Thank you! It really helps.
But I have obtained the error on kernel updating. (The step: Now install the last new kernel 2.6.21: apt-get install kernel-image-2.6.21)
After it the system does not boot and says about "Kernel panic". So I just work with 2.6.20.1 kernel.
Now I have the following trouble: the eBox does not see my second NIC. The first card is connected to WAN and has the eth1 interface, the second is conected to the LAN. At installation a system has found the both NICs and suggested to use the one of them as general. But now (after installation and installation eBox packages) it does not see the second card - eth0.
The ifconfig takes me the following:
eth1 ....
lo ...
The eth0 is absent here. The found card (that works normally [eth1]) is Realtec NIC.
The second card is VIA technologies (biult-in NIC) and it is not seen.
Could it be caused driver issues? Does a some way exist to enforce the system to see the second NIC (it has been found at installation)?
Thank you.
-
Please post you replies here: http://forum.eboxplatform.com/index.php?topic=164.msg560
I have moved the issue to more applicable topic.