Messages

1

Installation and Upgrades / Re: RAID setup as Secondary Drive

« on: November 14, 2012, 02:19:08 am »

Gparted Doesn't play well with MDADM RAID.

It might be easier to set the raid array as /home when you partition the drives.
Then partition the SSD as (1.5x RAM) for swap and the rest as /

Then when you add your samba shares just add the share path as "Directory under Zentyal" that will be on the RAID under /home/samba/share/"yoursharename"

2

Installation and Upgrades / Re: [SOLVED] Samba in zentyal 3.0???

« on: November 14, 2012, 12:41:57 am »

Also if you set a static IP in the initial configuration on first boot then it fills on those entries automatically.

3

Installation and Upgrades / Re: Openvpn road warrior acces to advertised network problem?

« on: December 22, 2011, 01:05:15 am »

The problem is that the default gw for your LAN clients is not Zentyal, so

1.- you enable NAT option on the VPN
2.- you add a route on your default gw to reach the VPN subnet via Zentyal
3.- you make Zentyal the default gw

Cheers,

Say for instance you are only running 1 nic for the network and its behind and adsl router how would you 2. Add a route on your default gw to reach the VPN subnet via Zentyal (vlan on router?)
3. Make Zentyal the default gw (add a nic and move the network to being behind the zentyal server?)

Thanks,
Kyser

4

Installation and Upgrades / Re: Zentyal 2.0.1 Port Forward problems

« on: October 25, 2010, 01:05:33 am »

Hi Guys,
          I'm having a similar issue with my setup, core version 2.0.5 latest updates installed as of yesterday. After I installed the updates the proxy server was not responding and I had to remove it and re-install it before it would show as running in dashboard. I don't know if that helps.

I have file sharing turned on http proxy on with the filter set to allow all. I have set up transmission on the same box for my torrents. I setup packet filtering to allow a service that I called "transmission" on a specific port and an object called "transmission" and added it to the list from external networks to Zentyal. When I check the logs it shows traffic incoming to that port that is dropped due to DOS attack. My router settings must be fine if the packets are getting logged. But when I check port forwarding from www.canyouseeme.org it either gets rejected or no response. The torrent site I use also confirms that I’m not connectable.  

I have scanned through about 20 pages of the forums looking for help and I just don’t see an answer for my issue. Is there something I’m doing wrong? Or another setting I need to change. Sorry if I wrote the settings the wrong way around as I don’t have remote access to the server right now = I’m at work.
Thanks,
Kyser

Edit
I have resolved the issue by changing the settings in packet filter to allow any source and the service for transmission to accept TCP/UDP on any source and destination port; basically I have turned off the firewall. If I even try to tighten it up to a port range or just TCP it drops all the packets for Transmission