Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
1
Installation and Upgrades / Re: Zentyal 5.0 install under LXD container - possible apparmor issue
« on: January 09, 2018, 08:31:04 am »
I have the same failure as well.
the lxc does not auto start ntp and bind9... and after systemctl enable bind9 systemctl enable ntp, everytime ntp need to be manually started.
same for samba-ad-dc, must manually run the systemctl start samba-ad-dc.service or put the entry in /etc/rc.local
However the webadmin does not allow me to make any configuration.
the lxc does not auto start ntp and bind9... and after systemctl enable bind9 systemctl enable ntp, everytime ntp need to be manually started.
same for samba-ad-dc, must manually run the systemctl start samba-ad-dc.service or put the entry in /etc/rc.local
However the webadmin does not allow me to make any configuration.
Code: [Select]
Command output: .
Exit value: 243 at /usr/share/perl5/EBox/Module/Service.pm line 964
EBox::Module::Service::restartService('EBox::Samba=HASH(0x6415200)', 'restartModules', 1) called at /usr/share/perl5/EBox/Util/Init.pm line 121
eval {...} at /usr/share/perl5/EBox/Util/Init.pm line 119
EBox::Util::Init::moduleAction('samba', 'restartService', 'restart') called at /usr/share/perl5/EBox/Util/Init.pm line 247
EBox::Util::Init::moduleRestart('samba') called at /usr/bin/zs line 62
main::main at /usr/bin/zs line 82
Pages: [1]