Zentyal Forum, Linux Small Business Server
Zentyal Server => Installation and Upgrades => Topic started by: itmakovec on October 31, 2014, 11:32:49 am
-
Hello, Everyone.
I have a problem booting from x64 iso of Zentyal 4.0, when I set up a Generation 2 virtual machine in Hyper-V 2012R2 for new installation, even with Secure Boot turned off. In Generation 1 the same iso booted with no problem.
With Ubuntu Server 14.04LTS there were no issues booting in Generation 2.
Any ideas as to why is this a problem for Zentyal?
Thank you.
ITMakovec
-
Did you do a MD5 check on the ISO to make sure the file is ok?
-
Did you do a MD5 check on the ISO to make sure the file is ok?
Thank you for the response. Of course I did. Moreover - the iso boots fine in Gen1...
-
Since this post I have abandoned installing from Zentyal Installer iso. Solution for me was installing minimal Ubuntu 14.04 into Gen2. I have followed "Best Practices for running Linux on Hyper-V" (https://technet.microsoft.com/en-us/library/dn720239.aspx) and then installed Zentyal from repositories using instructions from Installation Guide (https://wiki.zentyal.org/wiki/Installation_Guide).