Topics

1

Installation and Upgrades / After upgrade from 7.1 to 8.0 gateway is not working fine

« on: August 24, 2024, 05:37:52 pm »

Hi there,
after upgrage Zentyal form 7.1 to 8.0, all is working fine but gateway.

I have 3 network interfaces, one internal and two externals. Before the upgrade, all input traffic by the external interfaces was forwarded right to the local network.

With Zentyal 8, only "the default gateway" forward the traffic to the local network, the other one doesn't forward the traffic. If I'll change the default gw on the webadmin it doesn't work (no switching to the other external interface). Forwarding only works if I "disable" the first external interface, then input traffic is well redirected to the local network.

I built from scratch Zentyal 8 restoring the configuration backup of the upgraded Zentyal, but fail is persisting. Any suggestion?

Thx in advance.

2

Other modules / DHCP fails to assign fixed address

« on: August 25, 2023, 10:44:43 am »

Hi,
after delete a network object on Zentyal 7, DHCP is not assigning properly fixed IP's. If I check the logs I get the following message:

2023/08/25 08:57:57 DEBUG> Network.pm:5688 EBox::Network::objectMembers - objeto de red no existente: objc6. at objeto de red no existente: objc6. at /usr/share/perl5/EBox/Network.pm line 5688
EBox::Network::objectMembers('EBox::Network=HASH(0x55658f05fc88)', 'objc6') called at /usr/share/perl5/EBox/DHCP/Model/FixedAddressTable.pm line 225

Basically the message says that "objc6 doesn't exist". Any suggestion to solve this conflict?

Thans a lot!