Author Topic: Configuring as Master/Slave  (Read 2779 times)

jjmartin05

  • Zen Apprentice
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
Configuring as Master/Slave
« on: September 04, 2011, 01:09:40 am »
I'm trying to set up two systems as a "Master / Slave" setup. I have just installed zentyal and I cannot find where to set up the "slave" There is no option to do so under "Users and Groups"  Could someone please help me?   If you could give me some steps?

Thanks!

DWAM

  • Zen Warrior
  • ***
  • Posts: 113
  • Karma: +3/-0
    • View Profile
Re: Configuring as Master/Slave
« Reply #1 on: September 04, 2011, 02:29:21 am »
This topic was already discussed in the forum... Search for "users and groups module reinstall"

nicolasdiogo

  • Forum Moderator
  • Zen Samurai
  • *****
  • Posts: 263
  • Karma: +3/-0
  • a pessimist, but trying out optimism
    • View Profile
    • BrainPowered Business Intelligence Consultancy - UK
Re: Configuring as Master/Slave
« Reply #2 on: September 06, 2011, 01:11:12 pm »
Dwan

you are right this topic has been replied multiple times

and i also noticed that if you search for
"users and groups module reinstall"

as suggested - this topic is the only that is returned

so just in - the solution can be fond by searching:

ebox-usersandgroups-reinstall

this should list all posts describing how to reinstall the users and groups module


jjmartin05 - if this is sufficient info, please mark it as [S O L V E D]

thanks,

my opinions and suggestion expressed on this forum are my own as a user.
please note that i am not part of the Zentyal Development Team

www.brainpowered.net - supporting open-source Business Intelligence in Europe

DWAM

  • Zen Warrior
  • ***
  • Posts: 113
  • Karma: +3/-0
    • View Profile
Re: Configuring as Master/Slave
« Reply #3 on: September 06, 2011, 02:13:38 pm »
You're right, Nicolas : my answer was not precise enough.

This points out that the "Search" option in this forum is not very efficient, unless you already know what you expect to find ! And unless you have thought to do your search from the root of the forum rather than the current page you're reading...
« Last Edit: September 06, 2011, 02:18:00 pm by DWAM »