Hi,
Sorry for not giving details on my ebox setup before. Heres mine,
ebox1.4 - iso installation (updated by running ebox-software in console)
#interfaces
eth0 = 192.168.0.9 to LAN
eth1 = 192.168.1.9 to router1 (WAN checked)
eth2 = 192.168.2.9 to router2 (WAN checked)
eth3 = 192.168.3.9 to router3 (WAN checked)
#gateway (all enabled)
router1 = 192.168.1.1 (set as default)
router2 = 192.168.2.1
router3 = 192.168.3.1
#balance traffic (all enabled)
interface,source,destination,service = any & gateway=router1
interface,source,destination,service = any & gateway=router2
interface,source,destination,service = any & gateway=router3
testing method = utorrent download/upload, im confident it dint balance because only eth0 & eth1 led blinking while eth2 & eth3 led were static.
*i think the only time load balancer working were on my 1st few install. However im not 100% sure since im more focus on fail over function at that time. Now i have fresh install the ebox but i cant figure out why wont the load balancer working no matter what i try.
*now i got new issue, sometimes after reboot the ebox, i cant ping nor access the ebox via firefox from winxp machine. suprisingly i can ping & access with no problem on my debianbox. Then like 5 minutes later, i got no problem accessing ebox from winxp machine. Few test later shows that some other xp machine (& my debianbox) can ping to ebox while my xp machine cant.
Thanks for your attention.