I have Zentyal 5.0.8 fully patched (zentyal-network 5.0.6) with two interfaces eno1 (static IP used for management) and eno2 (Client access)
eno2 has 3 vlans setup on it 7,8 and 11
When i try to save settings the network module fails to restart
Looking at the log, Zentyal network appears to fail when trying to start and stop eno2, the root cause of this seems to be zentyal not creating an entry for eno2 in /etc/network/interfaces only entries for lo, eno1, vlan7, vlan8 and vlan11.
A network restart leaves the system with only eno1 up and no vlan access, and related services (dhcp,samba) not working correctly. Manual ifup works on the vlan interfaces and a reboot brings the system back to full working state until the next time network has to be restarted.
Example log line
EBox::Sudo::_rootError('/usr/bin/sudo -p sudo: /var/lib/zentyal/tmp/U_It3bMgEB.cmd 2> /var/lib/zentyal/tmp/stderr', 'set -e^J/sbin/ip address flush label eno2^J/sbin/ip address flush label eno2:*^J/sbin/ifdown --force -i /etc/network/interfaces eno2', 256, 'ARRAY(0x7c07d38)', 'ARRAY(0x34ea860)') called at /usr/share/perl5/EBox/Sudo.pm line 210
Any suggestions as to how to either get zentyal to write a dummy entry in /etc/network/interfaces for eno2 or stop the network module from trying to start eno2?
Richard