Hi Everyone!
I am new to Zentyal and so far I am having a blast setting it up and seeing our office start using some of zentyals features. I currently have zentyal setup and it is running on vmware vsphere hypervisor 5.1. Here is my current setup:
cisco router --->Zentyal --->cisco switch --->nodes (computers, printers, phones, etc)
So my issue is that the cisco phones are running on vlan 172 from the router and they work just fine if I connect them to the router. If I connect them on the switch, which is on eth1 as internal, they dont work. I have the switch setup with needed vlans and such but am unsure how to configure Zentyal so the phones can communicate with the router. My Zentyal setup is as follows:
eth0 is setup as external (192.168.99.254) and eth1 is setup as internal (10.24.82.254). eth0 goes to the router and eth1 goes to the switch. No vlans are configured on zentyal as I am not sure how to set this part up.
Is there a way to just have the voip traffic "passthrough" or will I need to setup vlans and somehow set the vlans to communicate with the router? Any help is very appreciated!
Thanks in advance!