Author Topic: [SOLVED] 4.0 iso boot issue in Gen 2 Hyper-V  (Read 2695 times)

itmakovec

  • Zen Apprentice
  • *
  • Posts: 6
  • Karma: +0/-0
    • View Profile
[SOLVED] 4.0 iso boot issue in Gen 2 Hyper-V
« on: October 31, 2014, 11:32:49 am »
Hello, Everyone.

I have a problem booting from x64 iso of Zentyal 4.0, when I set up a Generation 2 virtual machine in Hyper-V 2012R2 for new installation, even with Secure Boot turned off. In Generation 1 the same iso booted with no problem.

With Ubuntu Server 14.04LTS there were no issues booting in Generation 2.

Any ideas as to why is this a problem for Zentyal?

Thank you.


ITMakovec
« Last Edit: September 17, 2015, 09:01:56 am by itmakovec »

robb

  • Guest
Re: 4.0 iso boot issue in Gen 2 Hyper-V
« Reply #1 on: October 31, 2014, 09:29:41 pm »
Did you do a MD5 check on the ISO to make sure the file is ok?

itmakovec

  • Zen Apprentice
  • *
  • Posts: 6
  • Karma: +0/-0
    • View Profile
Re: 4.0 iso boot issue in Gen 2 Hyper-V
« Reply #2 on: November 04, 2014, 07:18:21 am »
Did you do a MD5 check on the ISO to make sure the file is ok?
Thank you for the response. Of course I did. Moreover - the iso boots fine in Gen1...

itmakovec

  • Zen Apprentice
  • *
  • Posts: 6
  • Karma: +0/-0
    • View Profile
Re: 4.0 iso boot issue in Gen 2 Hyper-V
« Reply #3 on: September 17, 2015, 08:56:25 am »
Since this post I have abandoned installing from Zentyal Installer iso. Solution for me was installing minimal Ubuntu 14.04 into Gen2. I have followed "Best Practices for running Linux on Hyper-V" and then installed Zentyal from repositories using instructions from Installation Guide.
« Last Edit: September 17, 2015, 09:08:17 am by itmakovec »