Author Topic: Using Zentyal to filter traffic between Cisco Router and the internet  (Read 1153 times)

Holtymet

  • Zen Apprentice
  • *
  • Posts: 1
  • Karma: +0/-0
    • View Profile
Below is the topology that I believe I require,

[INTERNET]===[Zentyal]===[Cisco Router]===[Switch]===[End Devices]

I am using the cisco router to route traffic between VLANs set up on the Switch, (I tried to eliminate the router and connected the switch straight to Zentyal howevewr the trunking did not work)

I figured, if i set all traffic destined for the internet to go out of the interface connected to the Zentyal router, on the cisco router, then Zentyal would be able to handle the request and forward them onto the internet. This is not the case however and pages do not load.

The cisco router is performing routing-on-a-stick on one interface (f0/1) and i have set a static route to route all traffic to go out of f0/1 (ip route 0.0.0.0 0.0.0.0 f0/0)

Could anybody point out were i may be going wrong.