Hi,
my server (2.2.7) has 2 ethernet interfaces. Eth0 ist used as external interface and eth1 uses the method vlan.
I defined four vlans 10 ... 13. Vlan11 ...13 have a static IP adress and vlan10 uses the method "bridged" with br1.
Br1 has a static ip adress and is used for connecting the virtal maschines.
Everything works fine until i reboot the server. All interfaces are up except vlan10 (ifconfig).
When i enter "sudo ifup vlan10" on the console i can ping the printer after a few seconds.
The logfiles doesn't show any error messages concering networks stuff.
Below i have attached the file /etc/network/interfaces witch i haven't changed by myself.
Thanks for any hint
Rainer
auto lo br1 eth0 vlan11 vlan12 vlan13
iface lo inet loopback
iface br1 inet static
address 192.168.99.1
netmask 255.255.255.0
broadcast 192.168.99.255
bridge_ports vlan10
bridge_stp off
bridge_waitport 5
iface eth0 inet static
address 192.168.98.2
netmask 255.255.255.0
broadcast 192.168.98.255
iface vlan10 inet manual
vlan-raw-device eth1
iface vlan11 inet static
vlan-raw-device eth1
address 192.168.100.1
netmask 255.255.255.0
broadcast 192.168.100.255
iface vlan12 inet static
vlan-raw-device eth1
address 10.0.0.1
netmask 255.255.0.0
broadcast 10.0.255.255
iface vlan13 inet static
vlan-raw-device eth1
address 10.0.1.0
netmask 255.255.0.0
broadcast 10.0.255.255